Fancyfox879

How I create RSA key and enable SSH access in Cisco VG202, in a Cisco router I use the next commands(but in a VG not exists): conf t. Crypto key generate rsa modulus 1024 ip domain-name domain-name ip ssh version 2 ip ssh time-out 120 ip ssh authentication-retries 3 line vty 0 4 transport input telnet ssh end. Once upgrade is completed, all was in order. MW-CORE-SW01 (config)#crypto key generate rsa The name for the keys will be: MW-CORE-SW01.magwinya.co.za Choose the size of the key modulus in the range of 360 to 4096 for your. OK apparently if you generate the crypto key with usage-keys it can be done even if there is no ip domain name command on the router. R2(config)#cryptokey generate rsa usage-keys label R2.cisco.commodulus 768% You already have RSA keys defined.

Q: I have a Cisco switch in my network, which I can access by hooking up a console cable directly to the device. I like to access the switch remotely using SSH. How can I enable ssh on my Cisco 3750 Catalyst Switch?
A: By default, when you configure a Cisco device, you have to use the console cable and connect directly to the system to access it. Follow the steps mentioned below, which will enable SSH access to your Cisco devices. Once you enable SSH, you can access it remotely using PuTTY or any other SSH client.

1. Setup Management IP

First, make sure you have performed basic network configurations on your switch. For example, assign default gateway, assign management ip-address, etc. If this is already done, skip to the next step.

In the following example, the management ip address is set as 192.168.101.2 in the 101 VLAN. The default gateway points to the firewall, which is 192.168.101.1

2. Set hostname and domain-name

Next, make sure the switch has a hostname and domain-name set properly.

3. Generate the RSA Keys

The switch or router should have RSA keys that it will use during the SSH process. So, generate these using crypto command as shown below.

Also, if you are running on an older Cisco IOS image, it is highly recommended that you upgrade to latest Cisco IOS.

Cisco Crypto Key Generate Rsa Command Link

4. Setup the Line VTY configurations

Setup the following line vty configuration parameters, where input transport is set to SSH. Set the login to local, and password to 7.

If you have not set the console line yet, set it to the following values.

5. Create the username password

If you don’t have an username created already, do it as shown below.

Note: If you don’t have the enable password setup properly, do it now.

Make sure the password-encryption service is turned-on, which will encrypt the password, and when you do “sh run”, you’ll seee only the encrypted password and not clear-text password.

5. Verify SSH access

From the switch, if you do ‘sh ip ssh’, it will confirm that the SSH is enabled on this cisco device.

After the above configurations, login from a remote machine to verify that you can ssh to this cisco switch.

In this example, 192.168.101.2 is the management ip-address of the switch.

If you enjoyed this article, you might also like..

Next post: How to Backup Oracle Database using RMAN (with Examples)

Previous post: How to Use C++ Single and Multiple Inheritance with an Example

Cisco Generate Crypto Key

Privacy Overview

Crypto Key Generate Rsa Command

Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.

Generate Rsa Key Command

Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies. It is mandatory to procure user consent prior to running these cookies on your website.